Forum

Replies

• PRO

  Gary RK March 15, 2017 at 2:11pm

  Ian, I'd guess attachment is not engaging properly before you tighten t bar. The female end in the power unit had little ramps built in to try and make the attachment engage in any orientation but doesn't always work.
  
  You try blipping throttle or manually turning attachment so the my mesh.
  
  You do get used to it.... :)
• PRO

  Harry@VWGS March 15, 2017 at 2:30pm

  One thing to check is that the head of the unit is actually attached to the shaft properly at the head end? Other than that it's as Gary has said... good luck
  • 

    Ian Parkes > Harry@VWGS March 15, 2017 at 3:36pm

    Took top off and re tightened seems fine now
    • PRO

      Harry@VWGS > Ian Parkes March 15, 2017 at 4:36pm

      Great...:-)
• PRO Supplier

  Progreen Weed Control March 15, 2017 at 3:13pm

  are the grey plastic inserts worn? Sit power unit vertically and push the attachment down firmly so it fully engages...its probably because its so new...not locating properly, as GRK said......I had the opposite problem, too much use caused a slack shaft..(no sniggering)...
  • PRO

    Gary RK > Progreen Weed Control March 15, 2017 at 5:18pm

    You need your shaft 'nip & tucked' then or a new 'end' ..... :D
• 

  Cheltenham Garden Maintenance March 15, 2017 at 7:09pm

  I bought some extra pins just in case for repair on the run