Etesia Launch New Attila 98X ride-on brushcutter

Etesia UK has announced the launch of the new Attila 98X four-wheel-drive ride-on brushcutter, which was officially unveiled ahead of the 2020 season at IOG SALTEX.

The new Attila 98X has been designed to work in the toughest of conditions. This powerful workhorse effectively deals with clearing vegetation from a wide variety of sites – long grass, weeds, bracken and brambles on woodland paths, orchards, verges and embankments.

Powered by the new Kawasaki FS691V 24HP electric start engine, the Attila 98X has a strengthened welded tubular chassis providing a better driving position for operators.

With a low centre of gravity, four-wheel-drive plus heavy-treaded tyres and differential lock, the new ride-on brushcutter to join the Attila family provides greater stability on slopes up to 30°.

Swing or fixed tip blades with a 98cm cutting height adjusted by a centralised lever with 8 working positions from 50mm-120mm plus transport mode enable this workhorse to cut through dense growth of up to 4.5cm diameter.

The new Attila 98X model joins the Attila range of pedestrian and ride-on brushcutters already available within the extensive Etesia portfolio.

For further information, please contact Etesia UK on 01295 680120 or visit www.etesia.co.uk

Evening what products are people using for black spot on roses, I'm about to run out of my current product which isn't available any more. many thanks

"I just use a couple of pieces of paper for the gap and then just rotate the flywheel to ensure its not rubbing anywhere. I set it up when the magnets are pulling the coil onto it with the paper as a sandwich between the two..................holds…"

"Thank you for your replies. As it happens, i just re-alligned the ignition coil slightly just to get it slightly closer to the fly wheel as i noticed one side had a bigger gap than the other, and fingers crossed it's been ok today so far. It does…"