PRO Supplier

Attraxor® helps control Poa annua

Attraxor® plant growth regulator (PGR) has helped Warren Moss – Head Greenkeeper at Dudsbury Golf Club, to suppress Poa annua and increase the quantity of Bent grass on the greens.

Attraxor®, a new BASF product, was recommended to Warren by David Chammings from Agrovista Amenity, and he was pleased to see an immediate response.

“The Poa had crept in and we estimated it to be at 70 percent in 2019,” said Warren. “Since starting with Attraxor® in May I have been able to suppress the Poa and through a reseeding program the greens are now 70 percent Bent, which is a great turnaround in such a short time period.”

Attraxor® has been shown to effectively regulate growth of managed amenity turf. The active substance, Prohexadione, inhibits the giberrelic acid pathway, which results in a reduction of turf height and turf biomass. Root growth is also promoted through the use of Attraxor® whilst turf colour and quality are maintained.

8701845058?profile=RESIZE_584x“This product is unique because it reduces clippings like other PGRs, but it also suppresses the seed heads of Poa annua,” explained Agrovista Amenity’s David Chammings. “It fitted well with what Warren needed to bring back the Bent in the greens at Dudsbury and we are both really pleased with the results.”

With the course south facing Warren said that extremely high temperatures over the past couple of years made maintenance very difficult. Poa started to creep in and the greens were left with very little Bent grass which was causing uneven surfaces and affecting playability.

On David’s advice, Warren applied Attraxor® at a low dosage of 0.375 kg/ha. The recommended application for Poa annua management is from 0.5 kg/ha to 0.65 kg/ha.

However, Warren needed to be cautious because of the high percentage of Poa on the greens. He started the Attraxor® treatment on 11th May and continued to apply it in 21-day intervals at the same dosage.

Warren chose overcast mornings to apply the product using Greenmaster Vitalnova Stressbuster and 2.5 kg/ha of N to prevent any yellowing.

8701909499?profile=RESIZE_584x“Using Attraxor® at 0.375 kg/ha was the right decision for this course and I have supressed the seed head production without yellowing the greens,” he said. “Unlike other PGRs I also noticed that it regulates the growth of the other grass varieties more consistently. I was especially impressed that it lasted the full 21 days.”

By suppressing the Poa, Warren has been able to reduce the amount of fertiliser and water needed on the course. “We were spending too much on fertiliser and using too much water to keep the Poa happy,” continued Warren. “However, this is water that we need elsewhere and so by using Attraxor® we have been able to improve the balance throughout the course.

“This year was the year to get aggressive with the Poa because there has been far less playing time for the members due to lockdown restrictions and I’m really pleased we took the plunge.”

The course was reseeded in August 2020 and Warren is hoping that this will increase the density of Bent to more than 80 percent by May 2021, when it has had chance to establish.

“I carried out the final application of Attraxor® on 12th August before our maintenance week and I plan to use it again from the end of April 2021 to tie in with competitions. It has really helped suppress the Poa and has given us the opportunity to return the greens to largely Bent in such a short time period that I want to keep it and make it part of the annual treatment program,” he concluded.

For more information about Agrovista Amenity, visit www.agrovista.co.uk/amenity

Votes: 0
E-mail me when people leave their comments –

You need to be a member of Landscape Juice Network to add comments!

Join Landscape Juice Network

Open forum activity

Oliver clarkson posted a discussion
Evening what products are people using for black spot on roses, I'm about to run out of my current product which isn't available any more. many thanks 
5 hours ago
Graham Taylor replied to Jamie's discussion Stihl BG86c problems
"I just use a couple of pieces of paper for the gap and then just rotate the flywheel to ensure its not rubbing anywhere.  I set it up when the magnets are pulling the coil onto it with the paper as a sandwich between the two..................holds…"
6 hours ago
Honey Badger replied to Jamie's discussion Stihl BG86c problems
"You're welcome. 
Im glad you got it working again."
8 hours ago
Jamie replied to Jamie's discussion Stihl BG86c problems
"Thank you for your replies. As it happens, i just re-alligned the ignition coil slightly just to get it slightly closer to the fly wheel as i noticed one side had a bigger gap than the other, and fingers crossed it's been ok today so far. It does…"
9 hours ago
Honey Badger replied to Jamie's discussion Stihl BG86c problems
"Replace there wiring you've probably worn out the kill switch. If it is a flywheel problem stop yanking the pull chord so hard, thats what shears of the flywheel key. I've had three bg86 they get a bit unreliable after 4-5 yrs. They all still run,…"
13 hours ago
John F replied to John F's discussion Service Schedule Stihl Cordless Hedge Trimmer ?
"Thanks Tim for the useful information , definitely worth mentioning also useful reminder to grease the gears regularly  
I must admit I sometimes forget with my more expensive kit which has the grease thread the grease soons dries out .
My Stihl…"
14 hours ago
Honey Badger replied to Jamie's discussion Stihl BG86c problems
"Get the flywheel off is tricky. Strip down both sides of the machine there's two opposing compression nuts you have to loosen the one on the fly wheel side. Use a punch and hammer to gently slide of the compression nut, there's a centre point the…"
15 hours ago
Honey Badger replied to Jamie's discussion Stihl BG86c problems
"Use a piece of cut plastic milk bottle to get the space right between the ignition coil and flywheel. The flywheel could be the problem. There's key on the flywheel that shears off and knocks the engine timing off. You have to remove the flywheel…"
15 hours ago
Tim Bucknall replied to John F's discussion Service Schedule Stihl Cordless Hedge Trimmer ?
"All the stihl kit I've got has grub screws for greasing, and stihl do grease in tubes like toothpaste.  Take the screw out (torx) and screw the tube in, squeeze some in.  Should be done quite regularly.  Also on shaft drive machines you should take…"
16 hours ago
Jamie posted a discussion
Hi all, hope this is in the correct thread.So i've had some BG86c blower problems recently. Long story short, i've replaced the carb with a genuine Stihl carb as my previous one wasn't priming, everything was fine once replaced but on full throttle…
16 hours ago
Honey Badger replied to John F's discussion Cherry Blossom Tree
"If it's right by a boundary wall it sadly needs to come out. Cherries are one of the worst for causing subsidence. People Are such idiots when it comes to planting tree's."
yesterday
John F replied to John F's discussion Cherry Blossom Tree
"Yes it's not always easy to do the right thing for the tree unfortunately whoever planted it put the wrong tree in the wrong place right next to a boundary wall when it was just a small tree .
Once it's pruned I  can't see it adding any value as it…"
yesterday
Peter sellers replied to Ben Hattersley's discussion Pricing for School grounds maintenance
"Ben, seems that you are in a strong position as you are well thought of by the school as you aren't the obvious choice to quote for something which is not your main business. Are they asking other contractors who do this type of work to quote? If…"
yesterday
Ben Hattersley replied to Ben Hattersley's discussion Pricing for School grounds maintenance
"Yes it seems to be mine field! The school arent happy with the current contractors and to be honest i wouldn't be either. The main concerns of the school are that they are paying for the contract but very little gets done.
Because i try stay away…"
Wednesday
Jim Mileman is now a member of Landscape Juice Network
Wednesday
Honey Badger replied to John F's discussion Cherry Blossom Tree
"Can't say I've ever seen silver leaf in 22 yrs because I don't prune prunus in the winter. The only dease I've seen on cherry is a die back due to old age. With exception a fungal thing that was poor soil related and did recommend to customer not to…"
Wednesday
More…

Stihl BG86c problems

Hi all, hope this is in the correct thread.So i've had some BG86c blower problems recently. Long story short, i've replaced the carb with a genuine Stihl carb as my previous one wasn't priming, everything was fine once replaced but on full throttle…

Read more…
6 Replies · Reply by Graham Taylor 6 hours ago
Views: 53