trends (4)

Top '10

As memories of the ice and snow we experienced in January melt away, our thoughts naturally switch to the spring and summer ahead and enjoying the outdoors again. So with the dawn of a new decade, it’s time to think of new ideas for our gardens for 2
Read more…

Open forum activity

Chris posted a blog post
We are thrilled to announce that Jacksons Fencing will be returning to FutureScape 2024 after almost a decade-long absence!As the market leader in premium quality fencing and outdoor products, we’re excited to showcase our innovative solutions at…
2 hours ago
Peter sellers replied to Rob's discussion Accurate costing for tree work
"Just re read this so £375 less £130 waste cost = £245 less roughly 25% tax and NI of £62 = £183, assuming 10 hours = £18 / hr . Far too cheap !"
3 hours ago
John F replied to Rob's discussion Accurate costing for tree work
"To be fair Rob I feel you did well to complete in 1.5 days .
Making a guess at Ten hours which equates to £37 per hour for fairly specialised hard graft especially the clearing up which you probably misjudged and I have myself more often than I…"
5 hours ago
Peter sellers replied to Rob's discussion Accurate costing for tree work
"Rob, we do a fair bit of tree work but we do have a 6 inch chipper which would have speeded the job up and reduced waste removal considerably guess we would have put a day on it so £450 plus vat plus £150 plus vat for grinding. On the face of it…"
5 hours ago
Adam Woods replied to Tim Bucknall's discussion E10 petrol
"The key os not to leave E10 in the tank/fuel system. I spend a  lot of time on motorcycles when not gardening.... I had one I was selling last year. I had put E10 in it and left it 3 months, in the garage. Would it start? No.
I drained the fuel and…"
6 hours ago
Billybop replied to Rob's discussion Accurate costing for tree work
"Cut Leylandii branches lie nice and flat but those trees obviously produced a lot of bulky waste. The small size of vehicle used, added to the time taken. Compared to a tipper type truck with high sides. This experience will have helped with costing…"
9 hours ago
Josh Thompson replied to Rob's discussion Accurate costing for tree work
"That puts you on about £160 a day before business costs are accounted for. Personally I do grounds maintenance excluding tree work and I aim for £200-£250/day in labour alone, if I was to remove waste it'd be cost + 1hr labour and hiring specific…"
12 hours ago
Rob replied to Rob's discussion Accurate costing for tree work
"It took me about 1.5 days and waste cost about £130Access is good though"
19 hours ago
Adam Pilgrim replied to Rob's discussion Accurate costing for tree work
"Basically, my 'tree guy' starts with stump grinding at £100. I don't know how small (or big) your van is, access to the job, your waste disposal costs incurred or how long it took you...
If it was around a half day- although I would have charged…"
20 hours ago
Rob posted a discussion
I recently cut down and removed 5 cupressocypress trees  that were between 10 and 14 foot high.  I ground the roots down below the ground, and removed all waste.   Three was approximately. 5   small van loads of waste. I charged. £375 including…
yesterday
MB posted a discussion
Just looking to get some hygiene kits for my 3M Optime III ear defenders and found a company called Best4Headsets.co.uk with free shipping at £50.00 and great prices.One team member Dale Benett e mailed me that there is a sister site…
yesterday
Peter sellers replied to Peter sellers's discussion Winter gloves
"Thanks, yes have seen that site and those gloves. We prefer a knitted wrist so go for the 292. However been trialling some Pfanner stretch flex polar at £6 which tick all the spec apart from conductive cold but seem more waterproof than the 292 and…"
yesterday
Ian Harvey replied to Peter sellers's discussion Winter gloves
"Check out safety gloves.co.uk. They have a range of EN511 1,1,1 rate gloves including the below, and also even cheaper Ejendals.
https://www.safetygloves.co.uk/ejendals-tegera-297-insulated-waterp..."
yesterday
Peel Projects updated their profile
yesterday
Graham Taylor replied to Tim Bucknall's discussion E10 petrol
"I always use E10 with no problems in Stihl equipment and mowers.   Worth remembering E5 still contains 5% ethanol     Why did your carbs need replacing?   Dealers are very quick to just fit a new carb rather than stripping he carb down, cleaning it…"
yesterday
Andrew Dean updated their profile photo
yesterday
More…

Accurate costing for tree work

I recently cut down and removed 5 cupressocypress trees  that were between 10 and 14 foot high.  I ground the roots down below the ground, and removed all waste.   Three was approximately. 5   small van loads of waste. I charged. £375 including…

Read more…
7 Replies · Reply by Peter sellers 3 hours ago
Views: 107

Ear Defenders Deals

Just looking to get some hygiene kits for my 3M Optime III ear defenders and found a company called Best4Headsets.co.uk with free shipping at £50.00 and great prices.One team member Dale Benett e mailed me that there is a sister site…

Read more…
0 Replies
Views: 20

Winter gloves

We generally buy Ejendals Tegera 292 gloves for Winter but at £20 plus £4 delivery wonder if there are gloves of equal performance at less cost?The specification we need as a minimum is compliance to EN 511 at level 1 for conductive cold , contact…

Read more…
5 Replies · Reply by Peter sellers yesterday
Views: 96

E10 petrol

We've had several machines fail recently (stihl hedgetrimmers and blowers) where the carburettor needs replacing- and on older machines, this can tip the balance from 'worth repairing' to 'not worth repairing'.  I suspect this is down to E10 petrol.…

Read more…
5 Replies · Reply by Adam Woods 6 hours ago
Views: 166