PRO Supplier

Early Easter doesn't mean it is spring!

Alan Abel from Complete Weed Control gives turf managers advice following the early Easter period.

With some warm sunshine during early April it seems as though spring has finally sprung. But with frost later in the month and lower than usual temperatures predicted, we cannot get sucked into ‎thinking it's time to apply selective herbicides and complete other spring type actions!

With daisies that have ‘over wintered’ and dandelions popping up everywhere it is tempting to get the sprayer out.

However, the uptake of the herbicide may not be successful unless perfect conditions are present. That is not only the weather conditions, but the water condition and the sprayer condition. This includes the correct nozzle selection giving the right water volume for the herbicide being applied.

Also, don’t forget that if the temperature is going to drop over night after an application, then scorch is likely to take place. The spray droplets are on or blown to the tips of the grasses or crop and when frost forms, that is what causes the scorch effect.

This is a phenomenon that has been seen in many fields after early spray applications by the farming fraternity this year. Scorch will severely set-back the grass growth ‎that we are desperate to have this year, so it MUST be that a spring flush really arrives before the sprayer temptation takes hold.

When Easter is early, as it was this year, Turf Managers see that as the starting gun for the season ahead, but it’s not the case. We must wait for the right conditions to prevail and patience is an important virtue. When discussions where mooted as to the fixing of the Easter date, that would be a good thing in our industry.

When the right time does come for applying selectives; then a tank mix with a soluble fertilizer should be considered to get the grass sward really moving. The pH of the water being used is so important and buffers should always be used to bring the water acidity to the correct level.

Manganese and Phosphites that are quickly available to the plant through the leaf would be worth looking for. It must be brought to your attention that this year will be the last time that the three way mixes of phenoxys that we have been used to will be able to be applied.

In 2017 we will see a big turn-around in terms of cost ‎when it comes to weed control in fine and amenity turf areas.

Complete Weed Control can give advice on all the above products and your local specialist can apply the correct product for your individual situation.

For more information, please contact Complete Weed Control’s national office on 01325 324 277 or visit www.completeweedcontrol.co.uk

You can also follow Complete Weed Control on Twitter @CWCLimited and view the company’s YouTube channel at www.youtube.com/user/completeweedcontrol1

Votes: 0
E-mail me when people leave their comments –

You need to be a member of Landscape Juice Network to add comments!

Join Landscape Juice Network

Open forum activity

Jamie replied to Jamie's discussion Stihl BG86c problems
"Thank you for your replies. As it happens, i just re-alligned the ignition coil slightly just to get it slightly closer to the fly wheel as i noticed one side had a bigger gap than the other, and fingers crossed it's been ok today so far. It does…"
27 minutes ago
Honey Badger replied to Jamie's discussion Stihl BG86c problems
"Replace there wiring you've probably worn out the kill switch. If it is a flywheel problem stop yanking the pull chord so hard, thats what shears of the flywheel key. I've had three bg86 they get a bit unreliable after 4-5 yrs. They all still run,…"
3 hours ago
John F replied to John F's discussion Service Schedule Stihl Cordless Hedge Trimmer ?
"Thanks Tim for the useful information , definitely worth mentioning also useful reminder to grease the gears regularly  
I must admit I sometimes forget with my more expensive kit which has the grease thread the grease soons dries out .
My Stihl…"
5 hours ago
Honey Badger replied to Jamie's discussion Stihl BG86c problems
"Get the flywheel off is tricky. Strip down both sides of the machine there's two opposing compression nuts you have to loosen the one on the fly wheel side. Use a punch and hammer to gently slide of the compression nut, there's a centre point the…"
5 hours ago
Honey Badger replied to Jamie's discussion Stihl BG86c problems
"Use a piece of cut plastic milk bottle to get the space right between the ignition coil and flywheel. The flywheel could be the problem. There's key on the flywheel that shears off and knocks the engine timing off. You have to remove the flywheel…"
6 hours ago
Tim Bucknall replied to John F's discussion Service Schedule Stihl Cordless Hedge Trimmer ?
"All the stihl kit I've got has grub screws for greasing, and stihl do grease in tubes like toothpaste.  Take the screw out (torx) and screw the tube in, squeeze some in.  Should be done quite regularly.  Also on shaft drive machines you should take…"
7 hours ago
Jamie posted a discussion
Hi all, hope this is in the correct thread.So i've had some BG86c blower problems recently. Long story short, i've replaced the carb with a genuine Stihl carb as my previous one wasn't priming, everything was fine once replaced but on full throttle…
7 hours ago
Honey Badger replied to John F's discussion Cherry Blossom Tree
"If it's right by a boundary wall it sadly needs to come out. Cherries are one of the worst for causing subsidence. People Are such idiots when it comes to planting tree's."
yesterday
John F replied to John F's discussion Cherry Blossom Tree
"Yes it's not always easy to do the right thing for the tree unfortunately whoever planted it put the wrong tree in the wrong place right next to a boundary wall when it was just a small tree .
Once it's pruned I  can't see it adding any value as it…"
yesterday
Peter sellers replied to Ben Hattersley's discussion Pricing for School grounds maintenance
"Ben, seems that you are in a strong position as you are well thought of by the school as you aren't the obvious choice to quote for something which is not your main business. Are they asking other contractors who do this type of work to quote? If…"
yesterday
Ben Hattersley replied to Ben Hattersley's discussion Pricing for School grounds maintenance
"Yes it seems to be mine field! The school arent happy with the current contractors and to be honest i wouldn't be either. The main concerns of the school are that they are paying for the contract but very little gets done.
Because i try stay away…"
yesterday
Jim Mileman is now a member of Landscape Juice Network
yesterday
Honey Badger replied to John F's discussion Cherry Blossom Tree
"Can't say I've ever seen silver leaf in 22 yrs because I don't prune prunus in the winter. The only dease I've seen on cherry is a die back due to old age. With exception a fungal thing that was poor soil related and did recommend to customer not to…"
Wednesday
Noel Dempsey replied to John F's discussion Cherry Blossom Tree
"It's not advised to prune cherry trees until the weather is warmer to prevent disease."
Tuesday
John F replied to John F's discussion Service Schedule Stihl Cordless Hedge Trimmer ?
"Many Thanks everyone . Sorted now , just removed the 4 torx screws and lifted gear box cover , original grease a bit dried out so cleaned it up removed debris and re greased gears .
Screwed cover back on and works as it should .
A nice…"
Monday
Billybop replied to John F's discussion Service Schedule Stihl Cordless Hedge Trimmer ?
"hi John yes its definitely a diy job to me, and i am not mechanically minded whatsoever. The higher end HSA trimmers have actual greasing points where you take the bolt out and put the grease in. The less expensive models you unscrew the plastic…"
Sunday
More…

Stihl BG86c problems

Hi all, hope this is in the correct thread.So i've had some BG86c blower problems recently. Long story short, i've replaced the carb with a genuine Stihl carb as my previous one wasn't priming, everything was fine once replaced but on full throttle…

Read more…
4 Replies · Reply by Jamie 27 minutes ago
Views: 24