PRO Supplier

A New Year, but what does it hold?

Alan Abel from Complete Weed Control gives Turf Managers his view ahead of 2017.

The years, when working within the turf and amenity industry seem to go very quickly, as we are always thinking about the next season ahead. Each of the four seasons brings its own challenges, be it weather, fixtures, disease outbreaks, weak sward – the list seems endless.

Turf managers must deal with these issues as they occur. It is no use waiting and seeing. Decision time is now, not tomorrow or next week. 2016 proved to be a reasonable year and the autumn/winter up to now, has been kind to us.

A lot of golf projects have been carried out in dry-ish conditions, which could not have happened in 2015 as it didn't stop raining for three months and the soil had reached saturation point.

So we never know what to expect. There has never been a more challenging time to live through than now. BREXIT seems to be the current buzz word and it is so unclear how it will work out with regards to the UK. The Sustainable Use Directive (SUDs) and our National Action Plan is such an important part of legislation and affects our industry in a big way.

We are losing many important active ingredients and although people may think no one is doing anything about it, this is far from the situation. The Amenity Forum, led by Prof John Moverley, is lobbying government ministers continuously on the sections behalf. As a body, The Amenity Forum is spelling out the problems that are happening in the field, highlighting the continual erosion of our arsenal of substances that we all require to keep our turf in the condition that has come to be expected.

They are explaining how professional we are in the amenity section and highlighting the necessity for the NSTS for sprayers, the importance of the Amenity Assured Scheme, and in general showing our industry in the best light while demonstrating that we are all dedicated to best practice and continual professional development.

On that subject, November 26 has passed, so all sprayers should hold NSTS certificates now. Agriculture HAS been through this development years ago. They have their sprayers checked and tested regularly, and they have had the Farm Assured Scheme running since the eighties. Our numbers in the amenity sector when it comes to BASIS qualifications are woefully low, as is the membership of NASOR or NoRosO. In my opinion, this is what is letting our industry down.

If the Government think for one minute this sector is being neglectful, then we will be under further restrictions. Glyphosate is also very much in the spotlight. There was a meeting in Virginia USA at the end of December made up of scientists making observations concerning the safety of this most important active ingredient.

The world simply cannot afford to be without this herbicide. End of. For your further information, please visit the Amenity Forum website to see the 'Get Moving' films. Update events are taking place in February, March and April which will be “do not miss” events!

So, challenging times lie ahead of all of us endeavouring to carry out our jobs in a professional manner – whether that be groundsmen, greenkeepers or contractors. Visit the Complete Weed Control website for all of the latest industry news and contact your local team for a survey of a particular situation or cost for a particular application – be it fungicide at short notice or any other requirement.

For more information, please contact Complete Weed Control’s national office on 01325 324 277 or visit www.completeweedcontrol.co.uk

You can also follow Complete Weed Control on Twitter @CWCLimited

Votes: 0
E-mail me when people leave their comments –

You need to be a member of Landscape Juice Network to add comments!

Join Landscape Juice Network

Open forum activity

Oliver clarkson posted a discussion
Evening what products are people using for black spot on roses, I'm about to run out of my current product which isn't available any more. many thanks 
3 hours ago
Graham Taylor replied to Jamie's discussion Stihl BG86c problems
"I just use a couple of pieces of paper for the gap and then just rotate the flywheel to ensure its not rubbing anywhere.  I set it up when the magnets are pulling the coil onto it with the paper as a sandwich between the two..................holds…"
3 hours ago
Honey Badger replied to Jamie's discussion Stihl BG86c problems
"You're welcome. 
Im glad you got it working again."
5 hours ago
Jamie replied to Jamie's discussion Stihl BG86c problems
"Thank you for your replies. As it happens, i just re-alligned the ignition coil slightly just to get it slightly closer to the fly wheel as i noticed one side had a bigger gap than the other, and fingers crossed it's been ok today so far. It does…"
7 hours ago
Honey Badger replied to Jamie's discussion Stihl BG86c problems
"Replace there wiring you've probably worn out the kill switch. If it is a flywheel problem stop yanking the pull chord so hard, thats what shears of the flywheel key. I've had three bg86 they get a bit unreliable after 4-5 yrs. They all still run,…"
10 hours ago
John F replied to John F's discussion Service Schedule Stihl Cordless Hedge Trimmer ?
"Thanks Tim for the useful information , definitely worth mentioning also useful reminder to grease the gears regularly  
I must admit I sometimes forget with my more expensive kit which has the grease thread the grease soons dries out .
My Stihl…"
12 hours ago
Honey Badger replied to Jamie's discussion Stihl BG86c problems
"Get the flywheel off is tricky. Strip down both sides of the machine there's two opposing compression nuts you have to loosen the one on the fly wheel side. Use a punch and hammer to gently slide of the compression nut, there's a centre point the…"
12 hours ago
Honey Badger replied to Jamie's discussion Stihl BG86c problems
"Use a piece of cut plastic milk bottle to get the space right between the ignition coil and flywheel. The flywheel could be the problem. There's key on the flywheel that shears off and knocks the engine timing off. You have to remove the flywheel…"
13 hours ago
Tim Bucknall replied to John F's discussion Service Schedule Stihl Cordless Hedge Trimmer ?
"All the stihl kit I've got has grub screws for greasing, and stihl do grease in tubes like toothpaste.  Take the screw out (torx) and screw the tube in, squeeze some in.  Should be done quite regularly.  Also on shaft drive machines you should take…"
14 hours ago
Jamie posted a discussion
Hi all, hope this is in the correct thread.So i've had some BG86c blower problems recently. Long story short, i've replaced the carb with a genuine Stihl carb as my previous one wasn't priming, everything was fine once replaced but on full throttle…
14 hours ago
Honey Badger replied to John F's discussion Cherry Blossom Tree
"If it's right by a boundary wall it sadly needs to come out. Cherries are one of the worst for causing subsidence. People Are such idiots when it comes to planting tree's."
yesterday
John F replied to John F's discussion Cherry Blossom Tree
"Yes it's not always easy to do the right thing for the tree unfortunately whoever planted it put the wrong tree in the wrong place right next to a boundary wall when it was just a small tree .
Once it's pruned I  can't see it adding any value as it…"
yesterday
Peter sellers replied to Ben Hattersley's discussion Pricing for School grounds maintenance
"Ben, seems that you are in a strong position as you are well thought of by the school as you aren't the obvious choice to quote for something which is not your main business. Are they asking other contractors who do this type of work to quote? If…"
yesterday
Ben Hattersley replied to Ben Hattersley's discussion Pricing for School grounds maintenance
"Yes it seems to be mine field! The school arent happy with the current contractors and to be honest i wouldn't be either. The main concerns of the school are that they are paying for the contract but very little gets done.
Because i try stay away…"
Wednesday
Jim Mileman is now a member of Landscape Juice Network
Wednesday
Honey Badger replied to John F's discussion Cherry Blossom Tree
"Can't say I've ever seen silver leaf in 22 yrs because I don't prune prunus in the winter. The only dease I've seen on cherry is a die back due to old age. With exception a fungal thing that was poor soil related and did recommend to customer not to…"
Wednesday
More…

Stihl BG86c problems

Hi all, hope this is in the correct thread.So i've had some BG86c blower problems recently. Long story short, i've replaced the carb with a genuine Stihl carb as my previous one wasn't priming, everything was fine once replaced but on full throttle…

Read more…
6 Replies · Reply by Graham Taylor 3 hours ago
Views: 50